Wortie Advanced Wart Remover

Product Description:

• The wortie Advanced warts and verruca remover is designed to treat stubborn and mature warts for patients aged 12 years and older.


• These mature warts often have a thicker layer of hard skin which can be more difficult to penetrate than younger warts.


• The conductive gel maximizes the performance by directing the
  cold temperature onto the application area.


• The tip of the Wortie Advanced Wart & Verruca remover is flat to
  maximize the contact with the wart for highly effective removal of stubborn warts.

How To Use:

• In most cases, only one treatment is needed for each wart.


• Consult your general practitioner if three treatments have not led to improvement.


• After Wortie is applied wait 14 days for the wart to fall off.


• In case the wart hasn’t changed within this time,you can apply Wortie a second time.
  Always wait 14 days between applications.


• Clean the applicator with alcohol on a small piece of cloth after each application.
  Allow the metal tip to reach room temperature after each application before reactivating for use on other warts.

  Instructions Of Use:

• Gently squeeze the gel tube to apply one single drop of the conductive gel exactly on the wart
  Remove the cap and place the can upright on a table or flat surface.


• Keep the can in the vertical position; put the cap back aligning the arrow icon of the cap with the freeze icon of the can.


• Press the cap down for 3 seconds (DO NOT EXCEED 3 SECONDS).


• You will now hear the activation sound(hiss).
  Precisely apply the frozen metal tip on the common wart (hand) for 20 seconds and for verruca (foot) 40 seconds


• In case of particularly verruca or sensitive skin (if you experience difficulties walking after treatment), a foam plaster can be used to protect the tender plantar wart area after treatment has been completed.


• Carefully remove foam plaster from backing.


• Apply adhesive side of foam plaster to skin with hole directly over the small tender spot.


• Clean the tip and put the cap back in close position and wait 14 days for the wart to go away.

Caution & Warnings:

• Extremely Flammable.


• Content under pressure.


• Do not pierce or burn aerosol spray can, even after use.


• Keep away from heat/sparks/open flames/hot surfaces - No smoking. Do not spray near an open flame such as candles or other ignition source. Do not expose to temperatures exceeding 50 Deg C/122 Deg F. Protect the device from sunlight and store in a dry and cool place.


• Piercing the container or exposure to the heat may
  cause the container to explode, causing serious injury.


• Avoid Contact with Eyes. Contact with eyes may cause blindness.


• If the product gets into the eyes, flush with water for 15 minutes and seek medical help immediately.


• Children cannot understand the instructions on how to properly use this product.

Ingredients:

• Dimethyl ether gas Conductive gel.


• Six protective foam plasters.

Product Details: